Installing Marlin Reprap Frimware to Ramps 1.4

This tutorial is for installing Merlin Firmware for Replicator Warehouse Prusa Mendel Iteration 2

1. Copy from /Marlin-Marlin_v1/ArduinoAddons/Arduino_oxx/libraries/LiquidCrystal the files to /Marlin-Marlin_v1/Marlin/

2. Start Arduino software

3. From the top menu select tools->board->Arduino Mega 2650

4. Click open select /Marlin-Marlin_v1/Marlin/marlin.pde

5 Make modifications if needed to the configuration (calibration etc…)

6. Click upload. After a minute or two you will see “Upload Done” message

Your new firmware is ready to use.